MAKING A MONOPRINT: STEP-BY-STEP

The following pictures illustrate the process of making a small monoprint similar to the one that was created in the video. You will need to prepare a registration paper that will determine the size of the final print. The registration lines are the size of the paper and the size of the plexiglass marked in the way that the image should appear on the paper.

Step 2 - Place the inked plexiglass on the press bed according to the registration lines.

Step 1 - Using a brayer, roll a thin layer of ink onto the plexiglass.

Step 3 - Compose the image by adding cut-out shapes or fabric to the plexiglass.

Step 4 - Cover the plexiglass with newsprint and felt blankets, making sure that everything is flat.

Step 5 - Roll the plexiglass through the press.

Step 6 - Carefully lift up the felt blankets and the newsprint.

Step 7 - Carefully remove the fabric from the plexiglass to reveal the textured image on the plexiglass.

Step 8 - Roll a different color on another piece of soft material, such as fabric or a doily.

Step 9 - Place the doily with the inked side up on the inked plexiglass.

Step 10 - With clean hands or gloves, place the dampened paper over the plexiglass.

Repeat the steps of covering the plexiglass with the newsprint and the felt blankets, and rolling the plexiglass through the press.

Step 11 -Lift the paper off of the plexiglass.

Step 12 - Here is the finished result!

If additional imagery is desired, continue by adding more layers to the print using the same methods. Keep in mind the importance of accurate registration as layers are added.

More information about monoprints can be found in the many resources listed on the Links section of this web site.

Copyright (c) 2000-2015 by Orna Feinstein, All rights reserved.